Permanent magnetic sine chuck Microsine
Tilting permanent magnetic chuck for clamping small and thin workpieces during grinding and eroding – single-tilting (longitudinal axis) or double-tilting (longitudinal and transverse axes).
1 / 3
- Sizes
- 175 x 100 – 600 x 300 mm
- Tilt range
- 0° – 45°
- Holding force
- approx. 80 N/cm²
- Pole division
- Parallel pole 1.5 + 0.5 mm
Description
These high-precision Microsine magnetic chucks are used for grinding as well as for eroding. They allow universal clamping of small, medium and large workpieces of any thickness, but are best suited to thin and fine workpieces.
The permanent magnetic chuck Microsine is the preferred choice when a flat, lightweight design is needed for grinding, eroding or milling.
A continuous, fine transverse pole distribution (steel/brass) ensures a consistent holding force over the entire width, right up to the long sides. The chuck is activated with a hexagonal switch lever.
Two versions are available: single-tilting about the longitudinal axis or double-tilting about the longitudinal and transverse axes. Gauge blocks allow the tilt angle to be set precisely up to 45°. The magnetic sine table is suitable for accurate grinding of workpieces with non-parallel surfaces.
Custom designs are available on request.
Advantages
- Single or double tilting
- Precise angle setting with gauge blocks
- The clamping surface can be machined to a maximum depth of 8 mm
- Liquid-tight
- Workpieces can be clamped quickly
- Low penetration depth of the magnetic force thanks to the flat magnetic field created by the fine pole pitch
- Smooth on/off switching via the switch lever
Technical data
| Model | Dimensions L x W [mm] |
|---|---|
| MS SI 1710 | 175 x 100* |
| MS SI 3015 | 300 x 150* |
| MS SI 4515 | 450 x 150* |
| MS SI 6030 | 600 x 300* |
* Swivel axis = length, or swivel axes = length + width. Further sizes on request.
